Friday, March 26, 2010

Never Disable IPV6 on SBS 2008!!!

Today I worked on a interesting issue.

One of my client holds a SBS Server with all roles like DNS, AD & Exchange 2007.

Actual issue: WMI not connecting from Monitoring Server. Getting error "No more threads can be created in the system. (Exception from HRESULT: 0x800700A4)"


In order to resolve this issue, rebooted SBS Server which caused another problem.
 
The server got stuck during booting, on “Applying Computer Settings" and was never booted up completely. Connected to Computer Management console from another comupter and verified eventlogs and services. Identified that Exchange Services were not started. Hence computer stuck on Applying Computer Settings.
 
 Tried booting the server in "Safe Mode with Networking", but all efforts were gone in vain.
 
After researching alot (for more than 2 hours) found that IPV6 was disabled on this SBS 2008 box.
 
Apparently, that’s what an SBS Server does ,when you kill some of it’s most critical services. I quickly learned that disabling IPV6 on an SBS 2008 server is extremely dangerous.


Stopping IPV6 leads to multiple failing services, and will cause your server to hang during booting as a result

The Solution



So, I had to re-enable IPV6. The fastest – and probably only – way was to boot the server into Safe Mode with networking services enabled. It’ll allow you to re-enable the protocol. Start the server again, and give it some time. Booting will take a few minutes longer than usual, but all your problems caused by
disabling IPV6 should be fixed now.

And reboot fixed DCOM/WMI Errors too..

Happy Learning!!!

2 comments:

  1. thanks for sharing the solution with us i like this information thanks

    sbs 2008

    ReplyDelete